The AN-114 OR table clamp is the most popular in a series of clamps in our product line. It is designed to hold a round bar (1/2" diameter) clamped vertically to the equipment hanger bar which is located on the sides and/or the head of an operating table. The round 1/2" bars can be straight or offset (e.g. AN-126) depending on their intended use in the operating room. They are used to hold transducers, manifolds, syringe holders and many other devices.
Other clamps are available with different features - see additional clamps under Options below)
FEATURES:
- The Offset Bar permits the transducer to be mounted close to the patient but not jammed up against the table.
- The distance from the operating table is adjustable up to six inches by rotating the Offset Bar in the table clamp.
- This unit allows for height adjustment when used with the table clamp. For example it may be necessary to adjust for heart level, etc.
- In some cases this unit may eliminate the clutter of an extra IV pole.
- If this unit is bumped or hit (using our clamps) it will hold the transducer unit secure but will allow it to rotate on the bar. This system will avoid damaging the transducer and reduces the possibility of bruising your hips and ribs.
- The ends of the Offset Bar have been rounded to facilitate easy setup and to reduce the chance of injury.
OPTIONS:
- Variations in height (up to six inches longer) may be requested at no additional charge. The bar as shown is the most popular size.
- Straight bars and other configurations may also be requested.
- A variety of clamps are available to hold these bars. The bar is designed to work with these clamps.
- IV poles with offsets are also available.